Firewood rack

cpufixerjr

Active member
Messages
40
Good Post Points
33
Location
Tulsa, OK
Welder
Lincoln 225 AC
My 7 year olds broke our lowes firewood rack...it was always a bit flimsy...so, I ran to the local supply shop and got some material to build this monstrosity.

2x1x1/8 channel iron base, 1.5x3/16 angle for uprights. 8 feet overall length.

I hit it a few times with the sledge hammer...lets see them break this one.
 

Attachments

  • 20200916_163542.jpg
    20200916_163542.jpg
    445.5 KB · Views: 308

Bearskinner

Well-known member
Messages
270
Good Post Points
85
Location
N. Idaho
Welder
Miller
Looks very sturdy. If when you load it, it deflects at all, you can add a piece of angle iron across the top, in the back so as not to bump into it, if it was on the front.
 

Gary Fowler

Well-known member
Messages
717
Good Post Points
200
I agree with Bearskinner that the uprights might bend especially if you load the bays unequally. I dont think you would need any stiffeners as long as you load/unload in both bays so they stay stacked level across.
 

Bearskinner

Well-known member
Messages
270
Good Post Points
85
Location
N. Idaho
Welder
Miller
Wish that was all the wood in needed! I keep 1 1/2 cords on the back porch and 5 more in the wood shed all dry and split, ready to use
 

Gary Fowler

Well-known member
Messages
717
Good Post Points
200
I have a mostly inexhaustible supply of heating material called electricity. I gave up on wood many decades ago. I would have natural gas heating if it was available here. I do keep a few propane bottles around to run emergency heat if needed when ice storms hit, which is rare. We were out of power for 7 days last April from a wind storm, 80+ MPH straight winds according to weather but it seemed certain 100 yard wide paths sustained major damage compared to the rest of the county where I live. If you were in those narrow paths of usually 100 yards wide or less, then it took down all the trees, where as, just next to that, nothing damaged. Luckily last April was cool so no need for AC and my 8000 watt generator kept the light, TV, internet and hot water working along with an electric skillet to cook on, we got by fine. That little genset purred day and night for a week. I filled it up at around 9 pm and it ran all night on 4 gallons of gas. Same for day time use, about 4 gallons for 8 hours of use. The only time I could hear it really load up was when the hot water heater kicked on,
 

cpufixerjr

Active member
Messages
40
Good Post Points
33
Location
Tulsa, OK
Welder
Lincoln 225 AC
I have a mostly inexhaustible supply of heating material called electricity. I gave up on wood many decades ago. I would have natural gas heating if it was available here. I do keep a few propane bottles around to run emergency heat if needed when ice storms hit, which is rare. We were out of power for 7 days last April from a wind storm, 80+ MPH straight winds according to weather but it seemed certain 100 yard wide paths sustained major damage compared to the rest of the county where I live. If you were in those narrow paths of usually 100 yards wide or less, then it took down all the trees, where as, just next to that, nothing damaged. Luckily last April was cool so no need for AC and my 8000 watt generator kept the light, TV, internet and hot water working along with an electric skillet to cook on, we got by fine. That little genset purred day and night for a week. I filled it up at around 9 pm and it ran all night on 4 gallons of gas. Same for day time use, about 4 gallons for 8 hours of use. The only time I could hear it really load up was when the hot water heater kicked on,

I remember ice storms here in Oklahoma as a kid and going without power for two weeks. Then in 2007, Oklahoma got hit by two really bad ice storms. My house in the city was without power for 7 days, straight out of college it was a learning experience. When we moved to the country in 2012, a fireplace was on my must have list. We mostly use it for an occasional night or weekend, let the boys roast marshmallow as a treat...it does help with the propane bill a bit, but I sleep better knowing it is there just in case. I also have a little generator, wanting to pick up a good gas driven farm welder also, maybe a little lincoln weldanpower.

It doesnt take much fence line clearing to get the 3 to 5 rick of wood I need every year.
 

cpufixerjr

Active member
Messages
40
Good Post Points
33
Location
Tulsa, OK
Welder
Lincoln 225 AC
Wish that was all the wood in needed! I keep 1 1/2 cords on the back porch and 5 more in the wood shed all dry and split, ready to use
Yeah, Oklahoma doesnt really get that bad and for occasional use, 3 to 5 rick is plenty and I can get all I need clearing fence lines...I can imagine having to keep up with that much firewood, almost a full time job.
 

Gary Fowler

Well-known member
Messages
717
Good Post Points
200
I remember ice storms here in Oklahoma as a kid and going without power for two weeks. Then in 2007, Oklahoma got hit by two really bad ice storms. My house in the city was without power for 7 days, straight out of college it was a learning experience. When we moved to the country in 2012, a fireplace was on my must have list. We mostly use it for an occasional night or weekend, let the boys roast marshmallow as a treat...it does help with the propane bill a bit, but I sleep better knowing it is there just in case. I also have a little generator, wanting to pick up a good gas driven farm welder also, maybe a little lincoln weldanpower.

It doesnt take much fence line clearing to get the 3 to 5 rick of wood I need every year.
My previous house (located in a Houston, Texas suburb) had a fireplace and I never used it. It was just an old standard fireplace, didnt have a heat-a-lator insert and it seemed to suck the heat out of the house rather than heat it up. I eventually cut a large piece of plywood and blocked it up.
For emergency heat in my house now, I purchased a radiant type 50K BTU propane heater. This conversation reminds me that I need to have some propane tanks refilled. I also just purchased a new patio set with a propane fire pit in the center of the table. My girls will enjoy that when they visit. They love to bundle up and set out on the patio and talk, drink some wine and play cards. The fire pit will enhance the experience I think.
 

Bearskinner

Well-known member
Messages
270
Good Post Points
85
Location
N. Idaho
Welder
Miller
You don’t need AC power of any kind to start a nice warm fire in the wood stove. Just a match, and it’s nice and warm. I still much prefer it over just turning up the thermostat
 

Gary Fowler

Well-known member
Messages
717
Good Post Points
200
Try one of the catalytic propane heaters. They burn much cleaner than a conventional propane burner
 

Dirt Guy

Well-known member
Messages
47
Good Post Points
17
Location
Sparks, Nevada
Welder
Miller 211, miller 135, Eastwood tig 200, Lincoln Weldenpower Engine driven Arc Welder,
I agree with Bearskinner. A wood stove is the only way to go , as long as you have a good source of wood. I have two wood stoves in my house and one in the shop. Always warm , here it gets pretty cold in the winter and snows.
 

Bearskinner

Well-known member
Messages
270
Good Post Points
85
Location
N. Idaho
Welder
Miller
Try one of the catalytic propane heaters. They burn much cleaner than a conventional propane burner
Had one in the back room of my shop (24x16) fully insulated. It would feel sticky wet. I had to get a dehumidifier. Removed it, and aged a pellet stove. Quick heat, dry and warm.
I live in the rain Forest, 80 miles from Canada, lots of rain and lots of snow. Dry works.
 

Gary Fowler

Well-known member
Messages
717
Good Post Points
200
It sounds like you might have a ventilation problem more so than just heating. Propane by itself doesnt create moisture, it comes from the combustion air around it. The fact that your wood stove discharges the burned fuel and combustion air makes it drier. You may have the shop too well sealed and therefore no air circulation which is a bad thing especially in an enclosed shop where you could be TIG welding.
 

Gary Fowler

Well-known member
Messages
717
Good Post Points
200
I agree with Bearskinner. A wood stove is the only way to go , as long as you have a good source of wood. I have two wood stoves in my house and one in the shop. Always warm , here it gets pretty cold in the winter and snows.
When you get my age minus 10 years or so, then cutting and splitting wood is not so enjoyable chore. Buying firewood is cost prohibitive around here for the amount of BTU that it produces. I prefer gas stove for cooking but electric for all other things but the wive hates gas stoves SO we have all electric home. I do have propane back up for heat and a small genset for the necessities of WiFi, computers, lights,TV and hot water with priorities being in the order listed. For myself, lights and hot water is all I need to get by, but wifey needs that computer and TV.
 

Gary Fowler

Well-known member
Messages
717
Good Post Points
200
Always warm , here it gets pretty cold in the winter and snows.
You know the worst thing about wood heat, getting up in the morning to start the fire and freezing your butt of while it heats up the room enough. The other thing is getting the heat from the room where the stove is back to the other rooms. Now if you have a wood fired boiler that uses hot water to heat, then the last item is not an issue.
 
Top