Custom gates, post and panels
- Thread starter jposey4564
- Start date
CB
Active member
- Messages
- 30
- Good Post Points
- 51
Nice work, @jposey4564 .
On the large rectangular gate, how did you join the 90 degree corners of the perimeter box tubing? The wetness of the long horizontal rail contrasts with the colorshift of the vertical rail, making the type of joint hard to discern, especially since your beads are solid without any porosity and flap disc blend so well as to not be able to really detect how the joint was formed.
The wet/dry light/shadow made the joint appear as if something other than a buffed out 45 miter, so I'm curious about it, along with what material the large gate frame is.
Again, some nice work there.
On the large rectangular gate, how did you join the 90 degree corners of the perimeter box tubing? The wetness of the long horizontal rail contrasts with the colorshift of the vertical rail, making the type of joint hard to discern, especially since your beads are solid without any porosity and flap disc blend so well as to not be able to really detect how the joint was formed.
The wet/dry light/shadow made the joint appear as if something other than a buffed out 45 miter, so I'm curious about it, along with what material the large gate frame is.
Again, some nice work there.