Recent content by jjef

Nice, I made one for my used and abused relic L4150 a few years ago when I replaced the rad, used repurposed channel, old tubes, heavy gauge angle, added a front hitch. Even rattle canned it orange. Bent tubes with a 16 ton hf bender. Will probably reconfigure lights and add mesh in between...

1/4" cement board, hardi backer? Its Fire proof with great compressive strength especially if you use thinset under it imo. However never used it Or seen it used for a shop floor, only as underlayment for tile over a wood floor

Nice idea wish I would have seen or thought of something like it before I bought my xl kindling cracker a few yrs ago.

I built this ATV trailer mover positioner quite a while ago using nothing but scrap steel and an old trailer ball, Modified to fit existing ATVs over the years, used a lot, easy to put on and take off ATV and works really good for moving my smaller single axle trailers as I'm sure some of you...

Don't really have advice on gophers cause we have some vicious ferrel cats in the area lol. however I started to "carefully" run an old towable homeowner grade lawn roller up and down my rows and since I started to get kind of good at it I run it in-between the rows cross directional. It...

Yes it is I don't shovel just run a bar into trench to widen it a little bit put tree in done. I also use a homemade wooden tree spacer. After a few years of experimenting currently run 6' rows with about 4.5-5'spacing between trees in rows, seems to work pretty good for my hobby operation...

My first welding project over 30:yrs ago. It's been reconfigured a half dozen or so times, used to have a flat bed with wood sides, currently repurposed a broken poly tow behind garden cart added and built the spring pin hitch after breaking multiple snowmobile bumpers widened the ski stance and...

Plant a few hundred Xmas trees every spring on our hobby operation. Built a homemade row marker beats making my field look like a new subdivision with string lines everywhere, basically just a 6 ' extension off a cheap subsoiler I bought used. Marker pin itself is an old snowmobile rear...

Here's mine I built for for 20 ton hf press made with pretty heavy duty cutoffs.

1st post, Built around 15 yrs ago, my welding carts used an old Lincoln 100 amp flux core welder, repurposed craftsman 22gauge bottom box I almost scrapped, welded to 3/16 angle iron lying around, old repurposed Yamaha snowmobile track axle for the rear, old swivel casters for the front, green...